ICF18, ICF32, ICF40, ICF60, ICF80DZ Operation
17
Connecting to an AC power supply
D
The coolers have an integrated multi-voltage power supply with priority circuit
for connecting to an AC voltage source. The priority circuit automatically
switches the cooler to AC operation if the device is connected to an AC power
supply, even if the DC connection cable is still attached.
When switching between the AC power supply and the battery supply, the red
LED may light up briefly.
1. Plug the AC connection cable (fig. 1 4, page 3) into the AC voltage
socket of the cooler (fig. 4 1,page 5).
2. Connect the connection cable to an AC power outlet.
6.4 Using the battery monitor
The device is equipped with a multi-level battery monitor that protects your
vehicle battery against excessive discharging when the device is connected
to the on-board DC supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler
switches off automatically as soon as the supply voltage falls below a set
level. The cooler will switch back on once the battery has been recharged to
the restart voltage level.
A
DANGER! Electrocution hazard
Failure to obey these warnings will result in death or serious injury.
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooler on board a boat from a AC
power supply, you must install a residual current circuit breaker
between the AC power supply and the cooler.
Seek advice from a trained technician.
NOTICE! Damage hazard
When switched off by the battery monitor, the battery will no longer
be fully charged. Avoid starting repeatedly or operating current
consumers without longer charging phases. Ensure that the battery
is recharged.
Igloo ICF18, ICF32, ICF40, ICF60, ICF80DZ_OPM_4445104001_APAC_en_202x-xx-xx.book Page 17 Thursday, September 28, 2023 6:55 PM
To Next Page
Loading...
