Igloo ICF80DZ - Page 22

EN
Operation ICF18, ICF32, ICF40, ICF60, ICF80DZ
22
To defrost the cooler, proceed as follows:
1. Take out the contents of the cooler.
2. If necessary, place them in another cooling device to keep them cool.
3. Switch off the device.
4. Leave the lid open.
5. Wipe off the defrosted water.
6.11 Replacing the AC fuse
D
1. Disconnect the power supply to the device.
2. Remove the connection cable.
3. Pry out the fuse insert (fig. 4 2, page 5) with a screwdriver.
4. Replace the defective glass fuse with a new one that has the same type
and rating (4 A, 250 V).
5. Press the fuse insert back into the housing.
6. Reconnect the power supply to the device.
6.12 Replacing the device DC fuse
1. Disconnect the power supply to the device.
2. Pry out the fuse cover (fig. 4 3, page 5) to access the fuse.
3. Reverse the fuse cover and use the hook to remove the fuse.
4. Replace the defective fuse with a new fuse of the same type (Automotive
Standard blade fuse, 10 A).
5. Re-fit the fuse cover.
6. Reconnect the power supply to the device.
6.13 Replacing the DC plug fuse
➤ Replace the DC plug fuse as shown in fig. 6, page 7.
➤ Disconnect the power supply to the cooler.
DANGER! Electrocution hazard
Failure to obey this warning will result in death or serious injury.
Disconnect the power supply and the connection cable before you
replace the device fuse.
Igloo ICF18, ICF32, ICF40, ICF60, ICF80DZ_OPM_4445104001_APAC_en_202x-xx-xx.book Page 22 Thursday, September 28, 2023 6:55 PM