ICF18, ICF32, ICF40, ICF60, ICF80DZ Operation
21
6.8 Setting the display brightness
The display brightness can be dimmed for low ambient light conditions. To set
the dimming level of the display proceed as follows:
1. Switch on the cooler.
2. ICF18, ICF32, ICF40, ICF60: Press the “SET” button (fig. 3 5, page 4) four
times.
3. ICF80DZ: Press the “SET” button (fig. 3 5, page 4) five times.
4. Use the “UP +” (fig. 3 7, page 4) or “DOWN –” (fig. 3 6, page 4) buttons
to set the brightness of the display.
✔ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✔ The display shows the set mode for several seconds. The display flashes
twice before it returns to the current temperature.
I
6.9 Switching off the cooler
1. Empty the cooler.
2. Switch the cooler off.
3. Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
➤ Leave the lid slightly open. This prevents odor build-up.
6.10 Defrosting the cooler
Humidity can form frost in the interior of the cooler or on the evaporator. A
layer of frost up to ~3mm thick is normal. Excessive build up however reduces
the cooling capacity, and should be defrosted periodically.
A
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically reverts to bright-
ness d0 (default). After troubleshooting the set brightness is
reactivated.
NOTICE! Damage hazard
Never use hard or pointed tools to remove ice or to loosen objects
which have frozen in place.
Igloo ICF18, ICF32, ICF40, ICF60, ICF80DZ_OPM_4445104001_APAC_en_202x-xx-xx.book Page 21 Thursday, September 28, 2023 6:55 PM
To Next Page
Loading...
