MAINTENANCE 9VX3
Clean the Fuel Filter Element
AWARNING
* Hot oil and components can cause personal injury.
* Fuel leaked or spilled on to hot surfaces can cause a fire.
Fuel filter
\
The fuel filter is located rear of the engine.
Ш
■Уну
1. Stop the engine.
2. Turn the fuel stop lever © to the “closed” (OFF) position.
3. Loosen the ring nut ©.
4. Remove the cup © and the element ©.
5. Drain water and sediment into a suitable container.
NOTE: Always dispose of drained fluids as established by local
regulations.
6 . Clean the inside surface of the cup and the element ©.
7. Install the clean element ©.
8 . Install cup ©. Tighten ring nut ©.
9. Turn the fuel stop lever © to the “opened” (ON) position.
NOTE: Do not start the engine until all fuel system service is
completed.
■ Priming the system
There should be enough fuel in the system to allow the
engine to start. Keep the engine start switch key at ON for
a period of 2 0 seconds, which operates the fuel pump and
priming automatically.
'Closed'
.....
ф Lever
”( )|)еП(чГ
2) Ring nut
\
■! Cup
l I dement
Fuel filter
4-7-4
To Next Page
Loading...
