OPERATION 9VX3
(D SWITCHES
5. Light Switch
Push down on the [/>*?] marked of the switch to turn the light on.
Push down on the blank half of switch to turn the working light off.
6. Engine Start Switch
д к и ш и
If the engine does not start after 10
seconds, return the key to OFF and wait
for two minutes before returning it to
START.
OFF : The engine must be in the OFF position to insert or remove
the key. Turn the key switch to the OFF position before trying to
restart the engine. Turn the key switch to the OFF position to stop
the engine.
ON : Turn the key clockwise to active the electrical system. The
key will return to the ON position when released from the START
position.
START : Turn the key to the START position to crank the engine.
Release the key as soon as the engine starts.
HEAT : In cold season, preheating is performed to facilitate engine
start. (This operation is unnecessary if the engine is warm.) Setting
the key to the preheat position starts heating the glow integrated
into the engine.
The preheating time should be 4 seconds or shorter. (The glow
may be burned if preheating is performed for more than 4
seconds.)
Turn the key to the start position to start the engine immediately
after preheating.
7. Horn switch
Push down on the top of the right operating lever to activate the
horn.
Stop Operation
(OFF) (ON)
Engine Start Switch
Horn switch
3-1-3
To Next Page
Loading...
