iHome iBTW281 - Setting the Time; Setting and Using the Alarms

3
SETTING THE TIME
1. Press and hold the Time Set Button located on the back of the unit
for 2 seconds until the clock display flashes and a beep sounds.
2.
Press the – or + Buttons to adjust the clock to the curr
ent time (hold
f
or rapid setting). Make sure you set the correct AM/PM time. Th
e PM
indicat
or appears to the left of the display; there is no AM indicator.
3.
To toggle the clock display between standard 12 hour time and 24
hour
(“military”) time displa
y, press the Alarm or Alarm Button
while
the displa
y is flashing during time setting.
4.
Press and release the Time Set Button to confirm the curr
ent time
setting. T
he YEAR will flash on the display. Press the – or + Buttons
to set the correct year (hold for rapid adjustment).
5.
Press and release the Time Set Button to confirm the current y
ear
setting. T
he Date will flash on the display. Press the – or + Buttons to
set the correct month, then press the Time Set Button to c
onfirm.
No
w press the – or + Buttons to set the day.
6.
Press and release the Time Set Button to confirm the current date
setting. 2 beeps will sound to indicate time setting mode is complete.
DAYLIGHT SAVINGS (DST) SWITCH
This unit has a DST switch on the bottom of the unit to adjust the time
for daylight saving time and standard time. By default, it is set to Auto
and will automatically adjust the time at the start and end of daylight
saving time.
If you wish to adjust manually, slide the switch to +1 to add one hour
or to –1 to subtract an hour.
This unit features dual alarms which can be set to dierent times and alarm
sour
ces. Each is set in the same way. Instructions are given as “Alarm
Button”; use Alarm 1 Button or Alarm 2 Button to set respective alarms.
Note: Each step must be completed while display is flashing or setting will
time-out with any changes saved.
1. Press and hold the Alarm Button for 2 seconds until the alarm time display
and alarm ic
on flash. A beep sounds.
2. Pr
ess the – or + Buttons to adjust the alarm time to the desir
ed time (hold
for rapid setting).
Make sure you set the correct AM/PM alarm time. The PM
indicat
or appears to the left of the display.
(continued on next page...)
SETTING AND USING THE ALARMS