iHome iH27 - Battery Management

5
Using The Remote Control Unit (Optional)
Install/Replace the Remote Control Battery (for models with remote control)
To order a remote control, visit www.ihomeaudio.com
The remote control battery is already installed at the factory. When the remote control
stops operating or its range seems reduced, replace the battery with a new one.
1.
The battery door is located on the back end of the unit.
2.
Slide the battery door to release the battery door latch and remove the battery door.
3. Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and – side of
the battery) is correct.
4.
Replace the battery compartment door back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Operating the remote control
The Remote Control controls basic functions on the iH27 and certain iPod
®
functions when the iPod
®
is docked in the iH27.
For best results, aim remote control towards the remote sensor by the lower right corner of the display.
Move the  Travel Lock Switch to Remote position to enable the remote control.
6
Sleep Button
iPod Play/Pause Button
Alarm Reset/
Power Off Button
Button
Button
Mute Button
SRS Button
Snooze/Dimmer Button
Volume Up Button
Volume Down Button
Turns iH27 OFF or resets alarm when alarm is sounding
Selects iPod and plays track. In play mode, press to pause
Toggles sound ON or OFF
Turn SRS WOW sound enhancement ON or OFF
Selects Sleep Time function
Snooze mode when alarm sounds, otherwise dims display
Lowers volume level
Raises volume level
Skip to previous or next track when iPod is playing, or
hold to scan current playing track.
Install/Replace Backup Battery
The iH27 uses a backup battery system to provide continuous alarm operation and
clock settings in the event of a power failure. If the Backup Battery Low Icon located
on the left of the display is flashing, it is time to replace the backup batteries. Please
make sure the AC adaptor is connected, otherwise all settings may be lost during
battery replacement.
Open the battery compartment cover located on the bottom of the unit in the left
battery compartment. Insert 1 “CR2032” battery as indicated. Replace battery
compartment covers.
Replacing iH27 Backup Battery
Battery install for
Clock display back up
The iH27 uses 4 “AA” batteries for portable playing. If sound becomes weak or
distorted while operating on batteries, it’s time to replace the batteries.The iH27 will
not charge iPod while operating on batteries.
• Open the battery compartment covers located on the bottom of the unit.
• Insert 2 AA batteries in each compartment as indicated, making sure the polarity
(+ and -) matches the diagram.
• Replace battery compartment covers.
Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium)
batteries.
Install/Replace Batteries for Portable Use