English
9
Virtual keyboard in iOS
Lorem ipsum dolor sit
amet, consectetur
adipiscin
Lorem ipsum dolor sit
amet, consectetur
adipiscin
Lorem ipsum dolor sit
amet, consectetur
adipiscin
To turn the virtual keyboard on/off, put the cursor into a text box and press the left foot-switch “up arrow” on the
BlueTurn and hold it for at least 3 seconds.
Startup notes
• Powering up iRig BlueTurn without holding any switch will cause it to boot in the last mode used and the
corresponding LED(s) will light up for a second.
• When iRig BlueTurn is powered on while holding one of the switches, both LEDs will constantly flash until a
switch is pressed. It is not possible to pair your Bluetooth device during this time, a mode must be selected.
• Modes have pre-assigned HID messages assigned to switch controls. The associations can’t be edited.
• Starting up iRig BlueTurn while holding both foot-switches will make it boot in boot-loader mode: only
needed for firmware updates.
• iRig BlueTurn is discoverable for 30 seconds upon start-up (and only after a mode has been selected). If no
device has been connected to iRig BlueTurn after this time, it will hide and must be turned off and then on
again.
Foot switch backlighting
Once iRig BlueTurn is paired with a device, the two foot-switches will light up with a backlight that allows for
easy operation when ambient light is low.
HOLD 3 sec.
HOLD 3 sec.
To Next Page
Loading...
Need help?
General