IKAWA V2-PRO - Beans Do Not Rotate in Roaster; Cannot Get Beans Out of Roasting Chamber

Problem:
I cannot get my beans out of the roasting chamber.
Cause:
This may happen because your beans have not roasted
sufficiently. They may be too heavy to be transferred from the
Roasting Chamber into the jar.
Solution:
1. Turn off your machine and disconnect the power supply.
2. Ensure your machine is cooled down by letting it stand for
at least 30 minutes.
3. Then take out the doser and jar.
4. Remove the glass lid by pulling upwards on each side (the
lid is attached magnetically).
5. You can remove the beans by tilting the machine on it’s
side to pour them out.
Problem:
The beans inside the roaster do not rotate.
Cause 1:
1. The air inlet at the bottom of the roaster may be blocked
with chaff or other debris.
Solution:
Allow the roaster to cool for at least 30 min. Turn the roaster
over and inspect the air inlet on the bottom of the machine. If
the air inlet is blocked with chaff or other debris unblock by
removing the debris.
Cause 2:
The roaster may be programmed with a roast profile with
inadequate air flow.
Solution:
Program the roaster with a higher air flow using the
IAKWApp.
6 TROUBLE SHOOTING
16