BATTERY REPLACEMENT
Battery replacement of the remote control
switch (Remote keyless entry system switch)
1- Separate the part 1 and 2 with the help of
hand pressing from the described line.
2- Then separate the upper and Lower part of
the section 2 by hand pressing (g B).
3- Remove the discharged battery and replace the
new one. Ensure the battery has been inserted
properly(g C). Use the battery of CR 2032.
4- Put the upper and lower part on each other
and insert it by hand pressing.
5- Put part 1 and 2 on each other and insert it
by hand pressing.
Warning
Never discard used batteries in
Nature. Give them to organizations
responsible for collecting and recycling
this kind of batteries.
Warning
Avoid keeping the battery or remote
controller in infants’ access, because
swallowing of the battery can cause
death. In case of swallowing the battery,
refer to health care centers immediately.
* If equipped
Battery Replacement of the Remote
Control Switch*
If the indicator light on switch is not blinked
or the key is not functioned correctly, it is
necessary the battery be replaced. For
replacement of the battery, rst open the
buckle and separate the switch back frame
with proper pressure to gap between up/down
frame. Conrmed battery is CR2032.
Remember; even, when the remote control
batteries have been discharged, central key
system operates by the key. If it's possible,
don't utilize used batteries.
To Next Page
Loading...
