Ikco SAMAND - Positioning the Jack

133
5
* If equipped
CHANGING WHEELS
Removing the Wheel Cover (only
for metallic rings)
Use the hook end of the trim remover to
unclip the wheel trim by pulling around the
wheel.
Notice:
In vehicles equipped with aluminum wheels,
Four screws are located in Jack Box to replace
the spare wheel. Fifth wheel is a temporary
wheel (to change in urgent situation and
when one of the tires is punctured). So there
is no problem if the manufacturer of the tire or
the tire crown is different from other aluminum
wheel tires.*
Warning
Always try to choose a safe place away from
the main trafc to replace the wheel. Take
out the passengers to a farther safe area.
Warning
Never work beneath the car when the jack
is the only support. Jack is only for replacing
the wheel.
Positioning the Jack
Put the jack in one of four points to the
wheel you decide to change.
- Make sure that jack rests on a plane level.
- Do not use a jack while passengers
sitting in.
-Make sure that front tires are completely in
direct alignment and the vehicle is in rst gear.
Jacking
1-Slacken the wheel’s four nuts using a
wheel brace.
2-Fit the wheel brace to the jack wrench,
put its ending hook into the jack ring, and
turn it counter-clockwise to raise it.
3-Remove the wheel top nut and t central
nipple.
4-Raise the vehicle until it detaches the
ground.
5-Unscrew other three nuts and remove
the wheel.
Removing Aluminum Sport Rings:*
The steps followed for replacing aluminum
ring are very similar to metallic ring, only
the wheel cover removal part is omitted.