Ikco SAMAND - Page 58

57
2
ALARM
Theft-Deterrent is active:
If the car is in “unlock” mode, the “lock”
button is pressed ,and doors are closed :
The doors are locked and shock sensor
is activated after 7 seconds. Siren and
asher are triggered once.
If there is any impact against the vehicle
at this time, the shock sensor is triggered
depending on the predened sensibility.
Therefore siren and ashers are activated
continuously for 30 seconds and the map
reading light stays on for 30 seconds
and the danger sign is displayed(2). If
shock sensor remains active for about 30
seconds, siren and asher are triggered
for 30 seconds too, map reading light
stays on and this trend continues, if the
shock sensor is not triggered, the returns
to theft deterrent position and memory
LED remains on, showing a danger till the
vehicle starts.
If in theft deterrent position one of the doors
becomes open, like the previous situation,
siren and asher are triggered, and the
checks the door after 30 seconds.
If the door is closed, the returns to theft
deterrent position, if not, door opening
alarm in theft deterrent position is activated,
meaning that the siren and ashers are
continuouslyactivated during 30 s. When
the vehicle is in theft deterrent position,
if (On) button on the remote control is
pressed, siren and asher turn on once
for conrming the activated theft deterrent
position (Panic) and map reading light turns
on and turns off with delay.
Remark:
1- Activating siren once means : siren
works for 20 ms.
2- One time activating of asher means,
asher works for 500ms