IKEA 501961066054C - 3-Wire Connection: Direct Wire; Make Gas Connection

14
3. Loosen (do not remove) the hex washer head screw and
insert the neutral (white) wire under the screw clamp at the
bottom of the center position terminal connector.
4. Insert the other 2 wires (lines 1 and 2) under the other 2 screw
clamps.
5. Securely tighten the hex washer head screws to
35 lbs-in. (4.0 N-m) minimum torque to make proper
electrical connection.
6. Tighten the locking ring of the conduit connector.
7. Replace the terminal block cover.
3-wire connection: Direct Wire
Use this method only if local codes permit connecting ground
conductor to neutral supply wire.
1. Loosen (do not remove) the hex washer head screws and
insert the neutral (white) wire under the screw clamp at the
bottom of the center position terminal connector.
2. Insert the other 2 wires (lines 1 and 2) under the other 2 screw
clamps.
3. Securely tighten the hex washer head screws to
35 lbs-in. (4.0 N-m) minimum torque to make a proper
electrical connection.
4. Tighten the locking ring of the conduit connector.
5. Replace the terminal block cover.
Make Gas Connection
The gas pressure regulator is supplied with the Gas Connection
Kit. Check that all parts are included.
1. Connect the gas pressure regulator to the pipe, using the
adapter.
2. Securely attach the pipe and plate underneath the range,
using the screws provided.
A. Insert wire under screw clamp.
B. Hex washer head screw
A. Line 1
B. Ground-link
C. Hex washer head screw
D. Silver-colored terminal
block screw
E. Neutral (white) wire
F. Line 2
G. UL listed conduit
connector and power
supply cable
A. Insert wire under screw clamp.
B. Hex washer head screw
A
B
A
B
C
E
F
G
D
A
B
A. Joint
B. Pipe
C. Plate
D. Adapter
E. Gas pressure regulator
A. Gas pressure regulator
B. Adapter
C. Plate
D. Pipe
A. Plate
B. Gas pressure regulator
C. Screws
A
B
C
D
E
A
B
C
D
A
C
B
A