17
GAS CONVERSIONS
Gas conversions from Natural gas to LP gas; or from LP gas to
Natural gas must be done by a qualified installer.
LP Gas Conversion
To Convert Gas Pressure Regulator
1. Turn manual shutoff valve to the “closed” position.
2. Unplug range or disconnect power.
3. Remove access cover from the gas pressure regulator.
IMPORTANT: Do not remove the gas pressure regulator.
Gas pressure regulator
4. Remove the access cap by using a wrench, turning the
access cap counterclockwise.
5. Remove sprint retainer from the cap by pushing against the
flat side of the spring retainer. Look at the spring retainer to
locate the “NAT” or “LP” position.
6. Turn over the spring retainer so the “LP” is showing on the
bottom.
7. Snap the spring retainer back into the cap.
8. Reinstall the cap onto the regulator.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 13" (33 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect wall anti-tip brackets to wall behind range.
Connect range anti-tip brackets to underside of range.
Re-engage the anti-tip brackets, if the range is moved.
See the installation instructions for details.
Failure to follow these instructions can result in death
or serious burns to children and adults.
WARNING
A. To range
B. Manual shutoff valve “closed“ position
C. Gas supply line
A. Gas pressure regulator
A. Access cap
B. Gasket
C. Gas pressure regulator
D. Spring retainer LP position
E. Spring retainer NAT position
A
B
A
A
B
C
D
E
LP
LP
To Next Page
Loading...
