IKEA Anratta - Permitted Use Guidelines; Installation Safety

ENGLISH 6
Never leave the appliance
unattended during food
drying. If the appliance is
suitable for probe usage,
only use a temperature probe
recommended for this oven - risk
of re.
Keep clothes or other
ammable materials away
from the appliance, until all the
components have cooled down
completely - risk of re. Always
be vigilant when cooking foods
rich in fat, oil or when adding
alcoholic beverages - risk of
re. Use oven gloves to remove
pans and accessories. At the
end of cooking, open the door
with caution, allowing hot air
or steam to escape gradually
before accessing the cavity - risk
of burns. Do not obstruct hot air
vents at the front of the oven -
risk of re.
Exercise caution when the
oven door is in the open or down
position, to avoid hitting the
door.
PERMITTED USE
CAUTION: The appliance is
not intended to be operated by
means of an external switching
device, such as a timer, or
separate remote controlled
system.
This appliance is intended
to be used in household and
similar applications such as: staff
kitchen areas in shops, ofces
and other working environments;
farm houses; by clients in hotels,
motels, bed & breakfast and
other residential environments.
No other use is permitted
(e.g. heating rooms).
This appliance is not for
professional use. Do not use the
appliance outdoors.
Do not store explosive or
ammable substances (e.g.
gasoline or aerosol cans) inside
or near the appliance - risk of
re.
INSTALLATION
The appliance must be
handled and installed by two or
more persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
IInstallation, including water
supply (if any) and electrical
connections, and repairs must
be carried out by a qualied
technician. Do not repair
or replace any part of the
appliance unless specically
stated in the user manual.
Keep children away from the
installation site. After unpacking
the appliance, make sure that
it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest After-sales Service.
Once installed, packaging
waste (plastic, styrofoam