IKEA Anratta - Oven Operation and Functions; Control Panel Usage; Initial Setup and Settings

ENGLISH 9
Control panel
A
Selection push-push knob
B
Back button
C
Light
D
Display
E
Conrmation button
F
Minute minder
G
Adjust push-push knob
Retractable knobs
To use this type of knob, press it in the middle.
The knob comes out.
Turn it to the required position.
Once cooking is over, turn the knob to and
press it again to restore it to its original
position.
Remove the accessories from the oven and
heat it at 200° for about an hour to eliminate
the smell and fumes from the insulating
materials and protective grease.
Settings
Turn the “Functions” knob
A
indicator to
display setting and turn the
G
knob to access
a submenu containing four display settings
which can be changed once cooking is over,
turn the knob to its original position.
• Clock
Turn the
G
knob to display CLOCK. The
two left digits will then start to blink, turn
the
G
knob to set hours. Press
E
button
to conrm the value and the right two digit
will start to blink. Turn the
G
knob to set
minutes and press the
E
button to conrm
the selection.
• Sound
To activate or deactivate the acoustic signal,
proceed as follows:
1. Turn the
G
knob to display “SOUND”
2. press
E
button to conrm
3. Use the
G
knob to select the desired
setting
First use
A D GB
C
EF
4. Press
E
button to conrm
• Brightness
To change the display brightness, proceed
as follows:
1. Turn the
G
knob to display
“BRIGHTNESS and press
E
to conrm.
2. The current brightness value is visible
3. Turn the
G
knob to increase or
decrease brightness and conrm by
pressing
E
.
• Eco
1. Turn the
G
knob to display “ECO”.
2. Press
E
to access the setting (ON/
OFF).
3. Turn the
G
knob to select the desired
setting and conrm by pressing button
E
.
4. During a cooking function, if the Eco
Mode is activated, the display reduces
the brightness to the lowest level
after 1 minute, the cavity lamp will be
switched off after 1 minute of cooking
and reactivated by pressing button
C
.