• Switch cooking zones off before the end
of the cooking time, to take advantage of
residual heat
• Bottom of pans and cooking zones should
be the same size.
Care and cleaning
Warning! Switch the appliance off and
let it cool down before you clean it.
Warning! For safety reasons, do not
clean the appliance with steam
blasters or high-pressure cleaners.
Warning! Sharp objects and abrasive
cleaning agents will damage the
appliance. Clean the appliance and
remove the residues with water and
washing up liquid after each use. Remove
also the remnants of the cleaning agents!
Scratches or dark stains on the glass
ceramic that cannot be removed do
not affect the functioning of the appliance.
Removing the residues and stubborn
residues:
1. Food containing sugar, plastics, tin foil
residues should be removed at once,
best tool for cleaning glass surface is a
scraper (not included with the appli-
ance). Place a scraper on the glass ce-
ramic surface at an angle and remove
residues by sliding the blade over the
surface. Wipe the appliance with a
damp cloth and a little washing up liq-
uid. Finally, rub the appliance dry using
a clean cloth.
2. Limescale rings, water rings, fat
splashes, shiny metallic discolorations
should be removed after the appliance
has cooled down using cleaner for
glass ceramic or stainless steel.
What to do if…
Problem Possible cause Remedy
The cooking zones will
not switch on or are not
functioning.
More than 10 seconds passed
since you switched on the hob.
Switch the appliance on again.
The child safety device is on
.
Deactivate the child safety de-
vice (See the section “Child
safety device ”).
The residual heat indi-
cator is not displaying
anything.
The cooking zone was only on
for a short time and is there-
fore not hot.
If the cooking zone is supposed
to be hot, call the After Sales
Service.
symbol plus a num-
ber appears on the
heat setting display.
Electronics fault. Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house’s electric system) If
after switching on again,
is
displayed again, call the cus-
tomer service department.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
If you operated the appliance wrongly,
or the installation was not carried out
by a registered engineer, the visit from the
customer service technician or dealer may
ENGLISH 8
To Next Page
Loading...
