11
please read carefully the Assembly Instructions and/
or the User Instruction section of this manual before
contacting us.
Inspect the hose before each use of the outdoor
cooking gas appliance. If it is evident there is excessive
abrasion or wear, or the hose is cut, it must be
replaced prior to the outdoor cooking gas appliance
being put into operation. The replacement hose
assembly shall be that specied by the manufacturer.
See gures below showing the correct burner
installation with respect to the burner orice.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Burner will not light using the
ignition system
LP gas cylinder is empty Replace with full cylinder
Faulty regulator Have regulator checked or replace
Obstructions in burner Clean burner
Obstructions in gas jets or gas
hose
Clean jets and gas hose
Electrode wire is loose Reconnect wire
Electrode or wire is damaged Change electrode and wire
Low ame or ashback (re in
burner tube - a hissing or roaring
noise may be heard)
LP gas cylinder too small Use larger cylinder
Obstructions in burner Clean burner
Obstructions in gas jets or gas Clean jets and gas hose
Windy conditions Use BBQ in a more sheltered
position
Gas valve knob dicult to turn Gas valve jammed Replace gas valve
To Next Page
Loading...
