IKEA ENEBY 30 - Getting Started; Adjust Volume; Add Bluetooth Device; Unpair Bluetooth Device

Getting started:
1. Connect mains cord into AC In (2)
connector.
2. A quick press on the knob (1) turn the
speaker On. ENEBY 20/30 starts to
search for paired devices. If a paired
device is found, the LED shines without
blinking and your speaker is ready to
use.
3. If no device is found the speaker LED
continues to blink and enters pairing
mode automatically. Go to the Bluetooth
settings in your mobile device and
connect to ENEBY 20/30. The LED should
now stop blinking and your speaker is
ready to use.
If no music has been playing for 20min,
the speaker will enter sleep mode.
Adjust Volume
Turn the knob (1) left to decrease or turn it
right to increase volume level.
Add additional Bluetooth device(s)
(max 8 devices)
1. Make sure no other device is paired and
in range to the speaker.
2. Go to your Bluetooth menu on your
mobile device and connect to ENEBY
20/30.
3. Once Bluetooth connection is
established, the white LED stops
blinking.
Unpair Bluetooth device
Go to your Bluetooth menu on your mobile
device and unpair ENEBY 20/30 from your
devices.
Play music from external source:
Connect a portable audio device to the
AUDIO IN (3) jack on the rear panel. The
speaker automatically detects the external
input and disables Bluetooth functionality.
Use a 3.5mm 3-pol Audio cable for this
feature.
Use speaker throughout home:
ENEBY 20 has the possibility to be portable.
ENEBY battery pack is sold separately.
— To insert the battery, open the
compartment lid (5) and insert the
battery in the correct direction.
— The battery is charging in the product
when mains cord is connected and the
speaker is turned on.
— When battery is low a red LED in the
knob (1) will ash. During charging the
red LED is on.
Attach Speaker to a wall or a stand:
ENEBY wall mount and ENEBY stand are
accessories and are sold separately.
Use holes (4) and included screws to mount
stand or wall mount. Do not over tighten
the screws.
5
Other settings:
Bass Control:
Treble Control:
Press knob (1) for 3 sec. LED ash slowly. This enters the bass
level control. Turn left/right to adjust. Conrm setting by pressing
knob one time. LED ash quickly.
Turn left/right to adjust treble and conrm by pressing the knob
one time and exit sound settings.
Factory reset:: Press the knob (1) for 10sec. This deletes paired Bluetooth
devices from the settings and restores default sound settings.