Make sure that you put the glass panels (A,
B and C) back in the correct sequence.
Check for the symbol / printing on the side
of the glass panel, each of the glass panels
looks dierent to make the disassembly
and assembly easier.
The screen-printing zone must face the in‐
ner side of the door. Make sure that after
the installation the surface of the glass pan‐
el frame on the screen-printing zones is not
rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the middle panel
of glass in the seats correctly.
How to replace: Lamp
Warning! Risk of electric shock.
The lamp can be hot.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
Before you replace the lamp:
Step 1 Step 2 Step 3
Turn o the oven. Wait until
the oven is cold.
Disconnect the oven from the
mains.
Put a cloth on the bottom of
the cavity.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a halogen, 230 V, 40 W, 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
ENGLISH 14
To download the full version visit www.ikea.com
To Next Page
Loading...
