IKEA HYGIENISK - Page 15

Latest programme selection
You can set the automatic selection of the
most recently used programme and options.
The latest programme that was completed
before the appliance deactivation is saved. It
is then selected automatically after you
activate the appliance.
When the latest programme selection is
disabled, the default programme is ECO.
TimeBeam
TimeBeam displays the following
information on the oor below the appliance
door:
• The programme duration when the
programme begins.
• 0:00 and CLEAN when the programme is
complete.
• DELAY and the countdown duration when
the delay start begins.
• An alarm code when the appliance has a
malfunction.
When AutoOpen opens the door,
TimeBeam is o. To check the
remaining time of the running
programme, look at the control
panel display.
Setting mode
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode
while the programme is running.
To enter setting mode, press and hold
simultaneously and for about 3
seconds.
• The lights related to , and
are on.
• The display shows the current value
of the rst available setting.
How to navigate in setting mode
You can navigate in setting mode using
programme buttons.
A B C
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between
the basic settings and to change their value.
Use OK to enter the selected setting and to
conrm changing its value.
How to change a setting
Make sure the appliance is in setting mode.
1. Use Previous or Next to select the
desired setting.
The display shows the current setting value
(a digit and the dedicated letter).
2. Press OK to enter the setting.
The current setting value ashes.
3. Press Previous or Next to change the
value.
4. Press OK to conrm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously
and
for about 3 seconds to exit
setting mode.
ENGLISH
15