IKEA HYGIENISK - Page 27

Problem and alarm code Possible cause and solution
The appliance trips the cir‐
cuit-beaker.
• The amperage is insucient to supply simultaneously all
the appliances in use. Check the socket amperage and the
capacity of the meter or turn o one of the appliances in
use.
• Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
Warning! We do not recommend
using the appliance until the
problem has been completely
xed. Unplug the appliance and
do not plug it in again until you
are certain that it operates
correctly.
The product number code (PNC)
If you contact an Authorised Service Centre,
you need to provide the product number
code of your appliance.
The PNC can be found on the rating plate on
the appliance door. You can also check the
PNC on the control panel.
Before checking the PNC, make sure the
appliance is in the programme selection.
1. Press and hold simultaneously
and
for about 3 seconds.
The display shows the PNC of your
appliance.
2. To exit the PNC presentation, press and
hold simultaneously
and for
about 3 seconds.
The appliance returns to the programme
selection.
The dishwashing and drying results are not satisfactory
Problem Possible cause and solution
Poor washing results.
• Refer to "Daily use", "Hints and tips" and the basket
loading leaet.
• Use more intensive washing programme.
• Activate the Power Clean option to improve the washing
results of a selected programme.
• Clean spray arm jets and lter. Refer to "Care and
Cleaning".
ENGLISH 27