Cleaning reminder
To remind you that Pyrolysis is necessary,
PYR flashes in the display for 10 seconds
after each activation and deactivation of
the appliance.
The cleaning reminder goes off the
display:
• After the end of the Pyrolysis function
•If you press + and - at the same time
while PYR flashes in the display.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of
electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deac-
tivate the circuit breaker.
Put a cloth on the bottom of the oven
to prevent damage to the oven light
and glass cover.
1. Turn the glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with a 25
watt, 230V (50Hz), 350 °C heat resist-
ant oven light bulb (Connection type:
E14).
4. Install the glass cover.
Cleaning the oven door
The oven door has four glass panels. You
can remove the oven door and the internal
glass panels to clean them.
The oven door can close if you try to
remove the glass panels before you re-
move the oven door.
Removing the oven door and the glass
panels
1
Open the door fully.
2
Lift and turn the lev-
ers on the two hing-
es.
3
Close the oven door
to the first opening
position (halfway).
Then pull forward
and remove the
door from its seat.
4
Put the door on a
soft cloth on a sta-
ble surface.
5
Release the locking
system to remove
the glass panels.
6
90°
Turn the two fasten-
ers by 90° and re-
move them from
their seats.
ENGLISH 17
To Next Page
Loading...
