Problem Possible cause Remedy
The oven does not heat up. The fuse in the fuse box is
released.
Do a check of the fuse. If the
fuse is released more than
one time, contact a qualified
electrician.
The oven lamp does not op-
erate.
The oven lamp is defective. Replace the oven lamp.
The Pyrolysis does not start.
The display shows C1.
The shelf supports are not
removed.
Remove the shelf supports.
The Pyrolysis does not start.
The display shows C2.
The Pyrolysis or Defrost
function is set when the plug
of the core temperature sen-
sor is in the socket.
Remove the plug of the core
temperature sensor from the
socket.
The Pyrolysis does not start.
The display shows C3.
The door is not fully closed
or the door lock is defective.
Fully close the door.
The display shows F102. The door is not fully closed
or the door lock is defective.
1. Fully close the door.
2. Deactivate the appli-
ance with the house
fuse or the safety switch
in the fuse box and acti-
vate it again.
3. If the display shows
F102 again, contact the
service centre.
The display shows an error
code.
There is an electronic fault. 1. Deactivate the appli-
ance with the house
fuse or the safety switch
in the fuse box and acti-
vate it again.
2. If the display shows the
error code again, con-
tact the service centre.
Steam and condensation
collect on the food and in
the oven.
You left the dish in the oven
for too long.
Do not keep the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing ends.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity. Do
not remove the rating plate from the appli-
ance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
ENGLISH 19
To Next Page
Loading...
