8
contact your gas supplier.
• Avoidthattheholeonthecover(VENT)is
obstructedorstopped(2).
• This regulator is not for use in caravans
and motor caravans.
Fitting the regulator on the valve
Make sure that:
• All the taps of the user appliance are
closed.
• The rubber hose is correctly fastened to
the regulator and user appliances.
• Makesurethehandleisinthe“closed”
position(thishappenswhenonthehandle
is visible a red rectangle with the marking
“OFF”)(Fig2).
• Remove the plastic protective plug from
the automatic valve.
• Pullthering(3)upwardsasshownin
gure3andttheKOSAN35ontothe
valve.Afterwardsgivethering(3)a
strong push downwards as shown in
gure4.A“CLICK”shouldbeheard,
meaning the regulator has been correctly
tted.
Operation
OPEN(ON):Aftercorrectlyttingthe
regulatorontothevalve,thegasow
can be opened by turning the knob a
half turn counterclockwise until the
stop, until you reach the opposite
horizontal position. In this position a
redamewith“ON”isvisibleas
showningure5.Inthispositionthe
valveisopenedandthegasowis
allowed.
CLOSED(OFF):Thegasowcanbe
stopped by turning the knob a half
turn clockwise until the stop, until you
reach the opposite horizontal position
“OFF”.Inthispositionthevalveis
closed.
Replacing the gas cylinder
Make sure that:
All taps of the user appliance are closed.
The opening knob of the KOSAN 35 is in the
closedposition(byturningitahalfturnuntil
thestop,theredameisnotvisible,“OFF”).
Afterwards, remove the regulator by pulling
thering(3)asshowningure6.Note:itis
not possible to pull the ring until the knob
is in the horizontal position and the marking
“OFF”isnotvisible.Thisisanimportant
security feature. The user must not try to
pull the regulator ring if the knob is not in
the“OFF”position.Pleasecontactyourgas
supplier if you have any problem.
System maintenance
• Toensurecorrectoperationoftheow
limiting device during gas supply, the
appliances hose length should be 1.5m at
maximum.
• If the system is not used for long periods
oftime(e.g.,inwinter),disconnectthe
pressure regulator of the tank. Protect the
pressureregulatortopreventanyying
mud.
• Normally the hose must be changed every
5 years.
• In normal conditions of use, to ensure
correct system operation, it is best to
replace the pressure regulator every
10yearsfromthedateofstartup.The
pressure regulator must conform to the
EN12864standard.
• When replacing the pressure regulator or
the hose, it may be necessary to replace
the clamps.
• After performing any maintenance
operations, always check the seal of the
system before starting it again.
• Thepressureregulatordoesnotrequire
any special maintenance jobs, but always
makesurethevent(2)isnotblocked.If
it is blocked, it can be freed by means of
a needle.
LIST OF FEATURES
The numbering of the product features
shown refers to the illustration of the
barbecue on the graphic page.
1. Handle
2. Hood
3. Cooking grill
4. Burners
5. Vaporizer bars
6. Grease tray
7. Control knobs
8. Barbecue body
USER INSTRUCTIONS
Before proceeding, make certain that you
understand the WARNING statements in this
manual.
• Preparation before cooking – To prevent