To Next Page
J
Jonathan WashingtonSep 18, 2025
What to do when the anti-flood device is on in my IKEA LAGAN FC223/92 Dishwasher?
- DdhubbardSep 18, 2025
If the anti-flood device is activated on your IKEA Dishwasher, close the water tap.
What to do when the anti-flood device is on in my IKEA LAGAN FC223/92 Dishwasher?
If the anti-flood device is activated on your IKEA Dishwasher, close the water tap.
What to do if my IKEA Refrigerator doesn't work?
If your IKEA Refrigerator isn't working, first, check if the appliance is switched on. If not, switch it on. Next, make sure the mains plug is correctly connected to the mains socket. If there's still no power, test the socket with another electrical appliance. If the socket still doesn't work, contact a qualified electrician.
Why is my IKEA Refrigerator not cold enough?
Several factors can cause the temperature in your IKEA Refrigerator to be too high or too low. Ensure the temperature regulator is correctly set to a higher or lower setting as needed. Make sure the door is closed properly. Allow warm food to cool to room temperature before storing it. If you have stored many food items at once, wait a few hours before checking the temperature again. If the frost is thicker than 4-5 mm, defrost the appliance. Lastly, minimize how often you open the door.
What to do if the lamp in my IKEA oven does not operate?
If the lamp in your IKEA oven isn't working, it's likely defective and needs to be replaced.
Why does IKEA LAGAN FC223/92 trip the circuit-breaker?
If your IKEA Dishwasher trips the circuit-breaker, the amperage might be insufficient for all appliances in use simultaneously. Check the socket amperage and meter capacity, or turn off another appliance. If this doesn't resolve it, there may be an internal electrical fault, and you should contact an Authorised Service Centre.
How to improve drying results in IKEA LAGAN FC223/92?
If you experience poor drying results with your IKEA Dishwasher: * Avoid leaving tableware inside the closed appliance for too long. * Activate AutoOpen to improve drying. * Ensure there's enough rinse aid; refill or increase the dosage level. * Consider the rinse aid quality. * Towel dry plastic items if needed. * Check if the programme includes a drying phase.
Why is my IKEA LAGAN FC223/92 Dishwasher causing dull, discoloured, or chipped tableware?
If you notice dull, discoloured, or chipped tableware after using your IKEA Dishwasher, ensure that only dishwasher-safe items are washed in the appliance. Load and unload the basket carefully and place delicate items in the upper basket.
What to do if temperature of the water inside IKEA LAGAN FC223/92 is too high?
If the temperature of the water inside the IKEA Dishwasher is too high or there is a malfunction of the temperature sensor, make sure that the temperature of the inlet water does not exceed 60°C. You can also try switching the appliance off and on.
What to do if my IKEA Ventilation Hood does not work?
If your IKEA Ventilation Hood isn't working, begin by checking if there's mains electrical power. If power is present, verify that the appliance is properly connected to the electrical supply. After checking these, turn off the appliance and restart it to see if the issue persists.
How to fix the light on my IKEA Ventilation Hood?
If the light on your IKEA Ventilation Hood isn't working, first check the light bulb to see if it's broken and replace it if needed. Also, ensure the light bulb is correctly fitted; if not, fit it properly.
General| Type | Freestanding |
|---|---|
| Width | 60 cm |
| Energy efficiency class | F |
| Number of place settings | 12 |
| Height | 85 cm |
| Depth | 60 cm |
| Child lock | Yes |
| Delay start | Yes |
