Why is the IKEA LAGAN S Dishwasher door difficult to close?
If your IKEA Dishwasher door is difficult to close, make sure that the appliance is level by loosening or tightening the adjustable feet (if applicable). Also, ensure that parts of the tableware are not protruding from the baskets.
What to do if my IKEA Dishwasher program does not start?
If the program on your IKEA Dishwasher doesn't start, first ensure that the appliance door is fully closed. Also, the appliance may be undergoing a resin recharge, which lasts about 5 minutes.
How to fix an IKEA Refrigerator door that doesn't close?
If your IKEA Refrigerator door won't close completely, check that the shelves are correctly positioned. Also, make sure to clean the door gaskets. Finally, ensure the refrigerator is level.
Why are there traces of rust on cutlery in my IKEA LAGAN S?
If you notice traces of rust on cutlery in your IKEA dishwasher, it might be due to too much salt in the water. Also, avoid placing silver and stainless steel cutlery together.
What does F111 mean on my IKEA Oven display?
If your IKEA oven display shows F111, the plug of the core temperature sensor is not correctly installed into the socket. Put the plug of the core temperature sensor as far as possible into the socket.
Why is there unusual foam during washing in my IKEA LAGAN S Dishwasher?
If you notice unusual foam during washing in your IKEA dishwasher, use detergent specifically designed for dishwashers. There may also be a leak in the rinse aid dispenser, in which case you should contact an Authorised Service Centre.
What to do if the salt indicator stays on in my IKEA Dishwasher?
The salt indicator might stay on in your IKEA Dishwasher after refilling the salt container if you're using salt that takes longer to dissolve. This doesn't affect the appliance's performance. If the indicator remains on after 3 or 4 cycles, contact the service.
Why does the IKEA Dishwasher programme lasts too long?
If your IKEA dishwasher programme lasts too long, check if the delay start option is set. If it is, cancel the delay or wait for the countdown. Also, activating the Power Clean option increases the programme duration.
Why am I getting poor drying results from my IKEA Dishwasher?
If you are getting poor drying results from your IKEA dishwasher, it could be because tableware was left inside for too long. Ensure there is enough rinse aid and that its quality is good. Always use rinse aid, even with multi-tablets. Note that plastic items may need towel drying, and some programmes may lack a drying phase.
Why won't the program start on my IKEA LAGAN S?
If the program on your IKEA Dishwasher won't start, first ensure that the appliance door is fully closed. Also, the appliance may be in the process of recharging the resin inside the water softener, which can take approximately 5 minutes.
General| Standard place settings | 13 |
|---|---|
| Place settings | 13 |
| Programs | 6 |
| Child lock | Yes |
| Delay start | Yes |
To Next Page
