What to do if the salt indicator stays on in my IKEA Dishwasher?
The salt indicator might stay on in your IKEA Dishwasher after refilling the salt container if you're using salt that takes longer to dissolve. This doesn't affect the appliance's performance. If the indicator remains on after 3 or 4 cycles, contact the service.
What to do if my IKEA Dishwasher won't start?
If the IKEA Dishwasher programme does not start, ensure that the appliance door is closed. Also, the appliance may have started the procedure to re-charge the resin inside the water softener, which takes approximately 5 minutes.
What to do if my IKEA Dishwasher doesn't drain the water?
If your IKEA Dishwasher isn't draining water, ensure that the sink spigot is not clogged and that the drain hose has no kinks or bends.
Why is there steam and condensation in my IKEA Oven?
If steam and condensation settle on the food and in the cavity of your IKEA Oven, it's likely because the dish was left in the oven for too long after cooking. To prevent this, avoid leaving dishes in the oven for more than 15 to 20 minutes after the cooking process has ended.
What to do if IKEA Dishwasher programme does not start?
If the programme on your IKEA Dishwasher isn't starting, try these solutions: * Ensure the appliance door is fully closed. * If the delay start is set, either cancel the setting or wait for the countdown to finish. * Note that the appliance may be recharging the resin inside the water softener, which takes approximately 5 minutes.
What to do if my IKEA Dishwasher has poor washing results?
For poor washing results with your IKEA Dishwasher, use more intensive washing programmes and clean the spray arm jets and filter. Refer to "Care and Cleaning."
Why is there unusual foam during washing in my IKEA LAGAN S Dishwasher?
If you notice unusual foam during washing in your IKEA dishwasher, use detergent specifically designed for dishwashers. There may also be a leak in the rinse aid dispenser, in which case you should contact an Authorised Service Centre.
How to remove limescale deposits on tableware in IKEA LAGAN S?
If you notice limescale deposits on the tableware, tub, or inside the door of your IKEA dishwasher, check the salt level and refill if low. Ensure the salt container cap is tight. Use salt and set water softener regeneration even with multi-functional tablets. For hard tap water, refer to "The water softener". You can also start the Machine Care programme with a descaler. If deposits persist, use suitable appliance cleaners or try a different detergent, contacting the detergent manufacturer if needed.
What to do if my IKEA Dishwasher does not drain the water?
If your IKEA dishwasher isn't draining water, check these items: * Ensure the sink spigot isn't clogged. * See if the interior filter system is clogged. * Confirm the drain hose has no kinks or bends.
Why IKEA Oven does not heat up?
Your IKEA oven might not be heating up due to several reasons: the oven might be deactivated, so you should activate it. The clock might not be set, so set the clock. The settings might be incorrect, so ensure they are correct. The automatic switch-off could be activated (refer to "Automatic switch-off"). The Child Lock might be on (refer to "Using the Child Lock"). Also, the door might not be closed correctly, so fully close the door. Finally, the fuse might be blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician.
General| Standard place settings | 13 |
|---|---|
| Place settings | 13 |
| Programs | 6 |
| Child lock | Yes |
| Delay start | Yes |
To Next Page
