IKEA LIVSLAGA - Gas and Control Adjustments; Gas Type Conversion and Injector Changes; Minimum Flame Setting Adjustment

ENGLISH 14
Makesurethattheoutletisneartheproduct
toinstall.So,ifthecablethatcamewiththe
productisnotlongenough,youwillneedto
replaceitwithanotheronehavingthesame
featuresbutwiththerightlength.
Adjustmenttodifferenttypeofgas
WARNING
- Thisoperationmustbeperformedbya
qualiedtechnician.
Iftheapplianceisintendedtooperatewith
adifferentgasfromthegastypestatedon
theratingplateandinformationlabelon
thetopofthehob,changetheinjectors.
Removetheinformationlabelandkeepit
withtheinstructionsbooklet.
Usepressureregulatorssuitableforthegas
pressureindicatedintheInstruction.
- Thegasnozzlesmustbechanged
byAfterSalesServiceoraqualied
technician.
- Nozzlesnotsuppliedwiththeappliance
mustbeorderedfromAfterSales
Service.
- Adjusttheminimumsettingofthetaps.
NOTE:whenliquidpetroleumgasisused
(G30/G31),theminimumgassettingscrew
mustbetightenedasfarasitwillgo.
IMPORTANT:shouldyouexperience
difcultyinturningtheburnersknobs,
pleasecontacttheAfterSalesServicefor
thereplacementoftheburnertapiffoundto
befaulty.
Replacingtheinjectors(seeparagraph
“injectortable”)
- Removegrids(A).
- Extractburners(B).
- Usingasocketspannerofthe
appropriatesizeunscrewtheinjector
(C),unscrewtheinjectortobereplaced.
- Replaceitwiththeinjectorsuitablefor
thenewtypeofgas.
- Re-assembletheinjectorin(D).
Beforeinstallingthehob,remembertoafx
thegascalibrationplatesuppliedwith
theinjectorsinsuchawaythatitcovers
theexistinginformationrelatingtogas
calibration.
Adjustingminimumgassettingoftaps
B
A
D
C
E