IKEA NEDDRAGEN - Island Installation; Typical Installation

5
F
E
D
A
Figure 2a – COUNTERTOP CUTOUT OPENING
Overhead Cabinet Should Not Exceed a
Maximum Depth of 15" (38.1 cm)
30" (76.2 cm) Min. Clearance
Between the Top of the Cooking
Platform and the Bottom of
an Unprotected Wood or Metal
Cabinet
24" (61 cm) Min. when
Bottom of Wood or Metal
Cabinet is Protected by
Not Less Than 1/8" Flame
Retardant Millboard Covered
With Not Less Than No. 28
MGS Sheet Steel, 0.015"
(0.4 mm) Stainless Steel,
0.024" (0.6 mm) Aluminum or
0.020" (0.5 mm) Copper
18"
(45.7 cm)
* Letters on this gure refer to chart on
previous page except for G and H.
H Min. From
Edge of Cooktop
to Nearest
Combustible Wall
(Either Side of
Unit).
25" Min.
(63.5 cm Min.)
Min.
MODEL G H
30"
4"
(10.2 cm)
7½"
(19.1 cm)
10"
( 25.4 cm)
*See
Figure 2b
*See
Figure 2c
Approximate Location of
Junction Box
12"
(30.5 cm)
For a drawer installation below
the cooktop, allow Dimension G of
clearance underneath the countertop.
The drawer must not interfere with the
electrical installation of the cooktop or
contain ammable materials.
Figure 2c– Minimum Recommended
Distance Between Rear Edge of
Cutout and Nearest Combustible
Surface Behind Countertop
Figure 2b– Minimum Recommended
Distance From Behind the Cabinet Front
1⅛"
(2.9 cm)
Island Installation
2"
(5 cm)
Typical Installation
Wall
backsplash