Problem and alarm code Possible cause and solution
The program lasts too long.
• If the delayed start option is set, cancel the delay setting
or wait for the end of the countdown.
The remaining time in the
display increases and skips
nearly to the end of pro-
gram time.
• This is not a defect. The appliance is working correctly.
Small leak from the appli-
ance door.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
The appliance door is diffi-
cult to close.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• Parts of the tableware are protruding from the baskets.
The appliance door opens
during the wash cycle.
• The AutoOpen is activated. This function opens the ap-
pliance door during the drying phase to improve the
drying performance and let the dishes cool down. The
door remains ajar.
– The duration of the drying phase and the door
opening time vary depending on the selected pro-
gram and options.
– When the AutoOpen opens the door, the display
shows the remaining time of the running program.
If you don't want the door to automatically open, deacti-
vate AutoOpen. Refer to "Settings".
Rattling/knocking sounds
from inside the appliance.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• The tableware is not properly arranged in the baskets.
Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the cir-
cuit-beaker.
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian-
ces in use.
• Internal electrical fault of the appliance. Contact an Au-
thorised Service Centre.
ENGLISH 24
To Next Page
