Why does my IKEA SMAKLIG automatically set a minimum power level?
If your IKEA hob automatically sets a minimum power level, it indicates that the power regulator is limiting the power levels according to the maximum value set for the hob. For detailed information on adjusting power settings, consult the “Power management” paragraph.
Why the IKEA SMAKLIG Hob does not allow a special function to be activated?
If your IKEA hob isn't allowing a special function to be activated, it's likely that the power regulator is limiting the power levels according to the maximum value set for the hob. Please, refer to the “Power management” paragraph for detailed instructions on how to adjust the power settings.
Why my IKEA Cookers appliance cannot be switched on?
If your IKEA Cooker won't switch on or operate, first, ensure it's properly connected to the electrical supply according to the connection diagram. If more than 10 seconds have passed since you switched it on, try switching it on again. Also, check if the Child Safety Device or Lock is activated and deactivate it if necessary. Finally, make sure you're only touching one sensor field at a time.
What to do if my IKEA Hob display does not react to touch?
If the display does not react to the touch, it could be that part of the display is covered, or the pots are placed too near to the display. Remove any objects covering the display and move the pots away from it. If the problem continues, wait 10 seconds.
Why does my IKEA Hob control panel switch off?
The control panel might switch off because of excessively high temperatures. This happens when the internal temperature of the electronic parts is too high. Wait for the hob to cool down before using it again.
What to do if IKEA Cookers acoustic signal sounds and appliance switches off?
If your IKEA Cookers appliance is sounding an acoustic signal and switching off, it could be that one or more of the sensor fields have been covered for more than 10 seconds. Make sure that you uncover the sensor field.
How to fix no signal when touching IKEA SMAKLIG panel symbols?
If your IKEA Hob isn't responding when you touch the panel symbols, the signals might be deactivated. You may need to activate the signals again. Please, refer to OffSound Control.
Why does my IKEA SMAKLIG Hob beep and deactivate?
If your IKEA Hob is beeping and turning off, it could be because one or more of the control panel symbols have been covered for more than 10 seconds. Make sure nothing is covering the symbols.
What to do if lights up on the IKEA SMAKLIG Hob timer display?
If you see that the symbol is lit on the timer display of your IKEA Hob, it means the overheating protection for the cooking zone is active. To resolve this, deactivate the hob, remove the hot cookware, and then, after about 30 seconds, reactivate the cooking zone.
Why is the residual heat indicator not working on my IKEA SMAKLIG?
If the residual heat indicator on your IKEA Hob isn't showing anything, it might be because the cooking zone was only on for a short time and hasn't heated up enough.
General| Type | Induction |
|---|---|
| Control type | Touch |
| Power levels | 9 |
| Timer | Yes |
| Child lock | Yes |
| Voltage | 220-240 V |
| Frequency | 50-60 Hz |
| Safety features | Overheating protection |
Guidance on safe use of the appliance by children and vulnerable individuals.
Crucial warnings regarding hot surfaces, unattended cooking, and fire hazards.
Steps and precautions for installing the appliance safely and correctly.
Requirements and procedures for connecting the appliance to the electrical supply.
Instructions for safe use, including handling wet hands and pacemaker users.
Specifications for voltage, power rating, wiring, and connection diagrams.
Initial steps for diagnosing and resolving common appliance issues.
Solutions for issues like the appliance not activating or operating.
Resolving issues with display errors, signal problems, and cookware detection.
To Next Page
