IKEA SMAKSAK Series User Manual

Heating
function
Application
Eco Fan
Cooking
This function is designed to
save energy during cooking.
For the cooking instructions
refer to "Hints and tips"
chapter, Eco Fan Cooking.
The oven door should be
closed during cooking so that
the function is not interrupted
and to ensure that the oven
operates with the highest en-
ergy efficiency possible.
When you use this function,
the temperature in the cavity
may differ from the set tem-
perature. The residual heat is
used.The heating power may
be reduced. For general en-
ergy saving recommenda-
tions refer to "Energy Effi-
ciency" chapter, Energy Sav-
ing.This function was used to
comply with the energy effi-
ciency class according to EN
60350-1. When you use this
function the lamp automati-
cally turns off after 30 sec-
onds.
Pyrolysis
To turn on the pyrolytic
cleaning of the oven. This
function burns off residual dirt
in the oven.
Setting a heating function
1. Turn the knob for the heating functions
to select a heating function.
2. Turn the control knob to select the
temperature. Press
to confirm.
The lamp turns on when the oven operates.
3. To turn off the oven, turn the knob for
the heating functions to the off position.
Turn the control knob to change the
temperature during cooking. Turn the knob
for the heating function to change a heating
function during cooking and press to
confirm.
Setting the function: Direct Steam
This function increases humidity during
cooking.
Warning! Risk of burns and
damage to the appliance.
Released humidity can cause burns. Do not
open the oven door when the function
works. After the function stops, carefully
open the door.
1. Fill the cavity embossment with tap
water.
The maximum capacity of the cavity
embossment is 250 ml.
Fill the cavity embossment with water
only when the oven is cold.
Caution! Do not refill the
cavity embossment during
cooking or when the oven is
hot.
2. Put food in the oven and close the oven
door.
Refer to "Hints and tips" chapter.
3. Set the function: Direct Steam .
4. Turn the control knob to set
temperature. Press
to confirm.
5. Turn the knob for the heating functions
to the off position to turn off the oven.
6. Remove water from the cavity
embossment.
ENGLISH
13

IKEA SMAKSAK Series Specifications

General

Energy Class	A
Voltage	220-240 V
Cooling fan	Yes
Type	Built-in oven
Functions	defrost
Cleaning	Catalytic
Cord Length	1.5 m
Frequency	50 Hz