22
EN
6
In the event of a power outage, the
power outage alert will illuminate
once power has been restored and a
tone will sound. Press any button to
silence the tone.
7
This alert indicates the door has been
open for 5 minutes or more. The
LED illuminates and the audible
alert sounds until the door is closed.
Turn the audible alert o by pressing
or by closing the door. If
the door is open for 5 minutes, the
interior light will turn o.
8
illuminates every 6
months or when you need to replace
the lter. Replace the lter, and
then press and hold
for 3 seconds to deactivate
the warning on display. See FILTER
REPLACEMENT for more information.
9
illuminates every 6 months
or when you need to replace the
lter. Replace the lter, and then
press and hold
for 3 seconds to deactivate the
warning on the display. See FILTER
REPLACEMENT for more information.
10
Press to select water. An
indicator light illuminate above the
active feature.
11
Press to select cubed ice. An
indicator light will illuminate above
the active feature.
12
Press to select crushed ice.
An indicator light will be illuminate
above the active feature.
13
˚F/˚C
To toggle between Fahrenheit (°F)
and Celsius (°C), simultaneously press
and hold + and for 5 seconds on the
refrigerator side of the display.
14
Prior to grocery shopping, we
recommend you activate
to lower the temperature
and cool food faster.
will remain active for up to 6 hours
before automatically deactivating or
manually exiting by pressing
to turn the function o. This
will reset the freezer to the previous
temperature setting.
15
The lter condition status is always
displayed when the door is open.
Press and hold for 3 seconds to reset
after changing the lter.
16
Press and hold for 3 seconds to reset
after changing the lter.
17
Toggles dispenser light On and O.
NOTE
The recommended settings for a product
installed in a kitchen is 37˚F for the
refrigerator and 0˚F for the freezer.
Press + or next to the Refrigerator or
Freezer temperature display to adjust the
temperature to the desired setting.
The temperature setting will begin to
blink with the rst touch. The display will
time out after 10 seconds and return to
the basic display.
CONTROLS AND SETTINGS
To Next Page
Loading...
