29
EN
STORAGE FEATURES
You can easily adjust shelf positions in the
refrigerator compartments to suit your
needs. The shelves have mounting brackets
that attach to slotted supports at the rear
of each compartment.
IMPORTANT
Be aware of the air seal located at the rear
of the shelf. Shelves located on the left
side should have the air seal mounted on
the far left side. Shelves located on the
right side should have the air seal mount-
ed on the far right side. This is to ensure
there is no interference with the large air
tower on the back wall of the cabinet. This
also applies to the crisper shelves.
1. Remove all food from the shelf.
2. Lift the front edge up and pull the shelf out.
1. Remove the air seal by pushing the seal
straight back.
2. Position the air seal toward the outside
edge of the shelf to avoid the air tower
when you push the shelf back into place.
3. Install the seal by sliding the open channel
end of the seal onto the back edge of the
shelf until the seal sits snug on the back
of the shelf and the ap sits at about a 10°
angle from the shelf surface.
1. Push the
front
half shelf
backward
toward the
rear of the
cabinet until
the rear
half shelf
drops down.
Then gently
continue pushing the front half shelf
back and under the rear half shelf.
3. Replace by inserting the mounting bracket
hooks into the desired support slots.
4. Lower the shelf and lock it into position.
CAUTION
To avoid personal injury or property
damage, handle tempered glass shelves
carefully. Shelves may break suddenly if
nicked, scratched, or exposed to sudden
temperature change. Allow the glass
shelves to stabilize to room temperature
before cleaning. Do not wash in dishwasher.
To Next Page
Loading...
