38
EN
Do not use with water that is microbiologi-
cally unsafe or of unknown quality without
adequate disinfection before or after the
system. Use systems certied for cyst
reduction on disinfected waters that may
contain lterable cysts.
• Rated Capacity - 125 gal/453 L
• Rated service ow - 0.50 gal/min.
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 lbs/in.²
• Recommended Minimum Operating
Pressure: 30 lbs/in²
The ice and water lter system is
tested and certied to NSF/ANSI
Standards 42, 53, 401 and CSA
B483.1 for the reduction of claims
specied on the performance
data sheet.
FILTER REPLACEMENT
You do not have to turn the water supply
o to change the lter. Be ready to wipe up
any small amounts of water released dur-
ing the lter replacement.
1. Turn the ice maker(s).
2. Remove the lter by pushing on the end/
face of the lter.
3. Slide the old water lter cartridge straight
out of the housing and discard it.
4. Unpack the new lter cartridge. Using
the alignment guide, slide it gently into
the lter housing until it stops against
the snap-in connector at the back of
the housing.
5. Push rmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
6. Press a drinking glass against the water
dispenser while checking for any leaks at
the lter housing. Any spurts and sput-
ters that occur as the system purges air
out of the dispenser system are normal.
7. After lling one glass of water, continue
ushing the system for about .
8. Turn the ice maker(s).
9. Press and hold on the
appliance control display for 3 seconds.
When the display changes from red to
green, the status has been reset.
To Next Page
Loading...
