43
EN
• There is no ice in the bin
to be dispensed.
• The refrigerator doors are
not completely closed.
• Dispenser paddle has
been pressed too long
and the dispenser motor
has overheated.
• See .
• Make sure the refrigerator doors are
completely closed.
• The motor overload protector will
reset in about three minutes and then
ice can be dispensed.
• Ice has melted and
frozen around auger
due to infrequent use,
temperature uctuations,
and/or power outages.
• Ice cubes are jammed
between ice maker and
back of ice container.
• Remove ice container, thaw, and
empty the contents. Clean container,
wipe dry, and replace in proper
position. When new ice is made,
dispenser should operate.
• Remove ice cubes that are jamming
the dispenser.
• Water lter not
seated properly.
• Water lter is clogged.
• Household water line
valve is not open.
• Remove and reinstall the water lter. Be
sure to push the lter in all the way until
it clicks into place and is secured inside of
the water lter housing.
• Replace lter cartridge. Be sure to
push lter all the way in until it clicks
into place and is secured inside of the
water lter housing.
• Open household water line valve. See
the CONCERN column of AUTOMATIC
ICE MAKER.
• The water dispensing
system is not designed to
chill water.
• Add ice to cup or container before
dispensing water.
• Water has not been
dispensed for an
extended period of time.
• Unit not properly connected
to cold water line.
• Draw and discard 10-12 glasses of
water to freshen the supply.
• Connect unit to cold water line that
supplies water to the kitchen faucet.
To Next Page
Loading...
