5
2. Hold the remote control close to
the light source you want to add (no
more than 5 cm away).
3. Press and hold the pairing button
for at least 10 seconds. A red light will
shine steadily on the remote control.
Your light source will begin to dim
and ash one time to indicate that it
has been successfully paired.
Up to 10 light sources can be paired
with 1 remote control. Make sure to pair
them one at a time. If the light sources
are close to each other, disconnect
those that have already been paired
from the main power switch.
FACTORY RESET YOUR DEVICES
For light sources:
Toggle the main switch 6 times.
For remote control:
Press the pairing button 4 times
within 5 seconds.
SYNCHRONIZING
If your light source becomes
unsynchronized, press and hold the
To Next Page
Loading...
