ENGLISH 4
Charger features
— Charge 1 to 2 pieces of HR6/AA and/or 1 to 2 pieces of
HR03/AAA rechargeable batteries.
— 2 charging channels.
— Charge is terminated by individual minus delta voltage
sensors (-dV).
— Safety by separate safety timer.
— Non-rechargeable and damaged batteries detection.
— Single colour LED indicator.
Operating instructions
— Connect the charger into an USB power outlet. LED indicator
will light up for 2 sec.
— Insert the batteries into the charging slots correctly
according to the polarity indications (+/-) see pic 1.
— The LED indicator status:
LED on: Charging in progress.
LED off: Charging complete.
LED ashing: Error
— The LED indicator will ash and the charger will stop
charging if non-rechargeable batteries or damaged batteries
are inserted into the charger by mistake.
Good to know
— Brand new batteries need 2 to 3 times of charging and usage
cycles to optimize the battery performance.
— It is normal for batteries to become hot during charging and
they will gradually cool down after charging.
— Charging time may vary based on different battery
capacities.
— Charging time may vary depending on remaining charge,
battery age and ambient temperature.
— Only to be supplied at SELV.
— Battery storage temperature: -20°C to 25°C.
— Charger operation temperature: 0°C to 40°C.
Disconnect the charger from the USB outlet before cleaning or
when it is not used.
Use damp cloth when cleaning the charger. Do not immerse
into water.
Caution recommendation: see label of charger.
Keep this manual for future use.
To Next Page
Loading...
