TOUCH CONTROL PANEL
Care should be taken in cleaning the touch control
panel. If the control panel becomes soiled, open the
microwave oven door before cleaning. Wipe the panel
with a cloth dampened slightly with water only. Dry with
a soft cloth. Do not scrub or use any sort of chemical
cleaners. Close door and touch STOP/CLEAR.
INTERIOR
Cleaning is easy because little heat is generated to
the interior surfaces. To clean the interior surfaces,
wipe with a soft cloth and warm water. DO NOT USE
ABRASIVE OR HARSH CLEANERS OR SCOURING PADS.
For heavier soil, use baking soda or a mild soap; rinse
thoroughly with hot water. The round wire rack and
shelf can be cleaned with hot soapy water, rinsed and
dried.
WAVEGUIDE COVER
The waveguide cover is located on the right side in the
microwave oven cavity. It is made from mica so requires
special care. Keep the waveguide cover clean to assure
good microwave oven performance. Carefully wipe with
a damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly catch re.
DO NOT REMOVE THE WAVEGUIDE COVER.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the
microwave oven. To remove, combine 1 cup water,
grated peel and juice of 1 lemon in a 2-cup glass
measuring cup.
Boil for several minutes using 100% power.
Allow to set in microwave oven until cool. Wipe interior
with a soft cloth.
TURNTABLE/TURNTABLE SUPPORT
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and non-abrasive
scouring sponge. They are also dishwasher-proof. Use
upper wirerack of dishwasher. The turntable motor shaft
is not sealed, so excess water or spills should be wiped
up immediately.
detergent. Rinse well and shake to dry or wash in a
dishwasher. Do not use ammonia. The aluminum
on the lter will corrode and darken.
the side slot, then push up and toward oven to lock.
Reinstall the 2nd lter using the same procedure.
Surface light replacement
1. Unplug the microwave oven or turn off power at the
main circuit breaker.
2. Remove the LED light cover mounting screws at both
light positions under the microwave.
Surface lights
Tab
Front
Rear
CAUTION
CAUTION
To avoid risk of personal injury or property damage,
do not operate oven hood without lters properly in
place.
To avoid risk of personal injury or property damage,
wear gloves when replacing the light bulbs.
Cleaning the grease filters
The grease filters should be removed and cleaned often;
Surface light replacement
To order parts call (833) 337-4006
generally at least once every month.
Grease filter part number 5304478913
Grease filters
the rear. Then pull lter downward and push to
the 2nd lter.
1. To remove the grease lters, slide the filter to
the other side. The lter will drop out. Repeat for
2. Soak the grease lters in hot water using a mild
3. To reinstall the grease filters, slide it into
EN
To Next Page
Loading...
Need help?
General
