Setting the TIME DELAY
1. Set an oven function and temperature.
2. Press again and again until starts
to flash.
3. Press or to set the time for
DURATION.
4. Press
.
5. Press or to set the time for END.
6. Press
to confirm.
Appliance turns on automatically later on,
works for the set DURATION time and stops
at the set END time. At the set time an
acoustic signal sounds.
7. The appliance deactivates
automatically. Press any button to stop
the signal.
8. Turn the knob for the oven functions and
the knob for the temperature to the off
position.
TIME DELAY works only for the
main oven.
Setting the MINUTE MINDER
1. Press again and again until starts
to flash.
2. Press or to set the necessary time.
The Minute Minder starts automatically
after 5 seconds.
3. When the set time ends, an acoustic
signal sounds. Press any button to stop
the acoustic signal.
4. Turn the knob for the oven functions to
the off position.
Cancelling the clock functions
1. Press the again and again until the
necessary function indicator starts to
flash.
2. Press and hold .
The clock function goes out after some
seconds.
Using the accessories
Warning! Refer to Safety
chapters.
Using the panel shield while grilling with
open oven door
When you use the grilling function with
open oven door it is necessary to attach the
panel shield below the control panel. It
prevents control panel damage because of
heat.
Warning! The shield will be very
hot when you use it while grilling.
Before you remove the shield
wait until it is cold. There is a risk
of burns.
1. Open top oven door.
2. Position the shield horizontally.
3. Make sure the text "For grilling use
only" is on top and you can read it.
The shield has magnets which let you
attach it below the control panel.
Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
ENGLISH 14
To Next Page
Loading...
