Ikegami TM20-20RH - Daily Adjustment; 5-1. Power

5. DAILY ADJUSTMENT
Under normal usage conditions, the prescribed performance can be obtained by just operating the adjusters below.
The switch LEDs in the explanation below express the following meanings :
~ ... LED Off
I~ I · .. LED blinking
0 ··· LEDOn
5-1. Power
POWER IN
[J
AC1 00V -A C120 V
AC200V-A C2'0 V
FUSE 4A
@ (i)FUSE
MAIN
0 POWER
I
I I --~---®MAIN POWER SWITCH
Fig. 5-1 Rear Panel
(l)Power ON
{2)AC Input Supply Voltage and Fuse
After switching "ON" the !.MAIN POWER] switch
indicated by ® on Figure 5-1, if you switch "ON" the
IPOWERi switch on the front left panel, the POWER
LED lights up and the system comes on. (The system
is shipped from the factory with this switch "ON".)
When you switch the power off, it is normal to just
switch "OFF" the front
panel !POWER! switch. There
is no need to switch "OFF" thelMATN POWERjswitch.
- 12 -
Since the AC input voltage is switched automatically,
there is no need to change any switches when changes
lx>tween 100-120 VAC and 200-240 VAC.
& CAUTION
• If the fuse is burnt out, check the circuit trouble before changing
the fuse.
• Tum the power OFF before changing because an electric shock
or trouble may
be caused.
• Be sure to use a fuse of the specified type and capacity.
]
:J
··.J.·
.·
:..J
: . .!
.
J
.
,·J··
..
U
....
.
.