13
10 Model Memory with Pair Safe Technology
Your transmitter can store up to 10 models in memory, where all of the
settings are stored independently for each model. This enables you to use
one transmitter with up to 10 different vehicles. Incorporating Pair Safe
technology ensures the transmitter will only control the receiver that is
paired to the currently selected model. This prevents a common and unsafe
run-aways from vehicles that were left on by accident or turned on when
the transmitter was set to a different model. When your transmitter powers
ON, it will produce a signal by ashing the LED beeping a number of times
corresponding to the currently selected model (1-10). As an example, if you
are in model 3 when the transmitter turns on, the LED will ash 3 times and
you will hear 3 beeps.
CAUTION: WHEN A VEHICLE IS TURNED ON BUT THE INCORRECT MODEL IS
SELECTED, THE RECEIVER WILL ACTIVATE THE FAIL SAFE. TO PREVENT RUN-
AWAYS YOU MUST STILL PROPERLY SET THE FAIL-SAFE POSITION FOR EACH
MODEL AFTER PAIRING AND INITIAL CALIBRATION (CHANNEL REVERSING AND EPA
SETTING).
Note: The included receiver is paired to model 1 from the factory.
1. To change the current model follow these steps.
2. Hold down the “Model Select” button while powering ON the transmitter.
3. The transmitter will emit the signal corresponding to the current model.
Press the “Model Select” button to scroll through the available models.
4. When the model you want is selected, simply power OFF and back ON the
transmitter and the model will be loaded into memory. If you do not press
the “Model Select” button before powering OFF when in the model select
mode, the same model will be kept in memory.
To help identify the vehicles paired with each model, we have included two
decal sheets which allow you to apply numbered and silhouette decals onto
your vehicle and transmitter that match the number on the main transmitter
to the type of vehicle paired with that model.
Model Select
button
To Next Page
