EasyManua.ls Logo

Ikra IBF 25-1 User Manual

Ikra IBF 25-1
80 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
73711526-04
Benzin Freischneider
Petrol brushcutter
Coupe-bordures à essence
Decespugliatore a benzina
Benzinski čistač trave
Motorna kosa
IBF 25-1
IT
Prima della messa in funzione leggere le istruzioni per l‘utilizzo!
Istruzioni per l’uso - Traduzione delle istruzioni per l‘uso originali.
GB
Operating Instructions - Translation of the original Operating Instructions
Read operating instructions before use!
FR
Lire attentivement le mode d‘emploi avant chaquemise en service !
Mode d‘emploi - Traduction du mode d’emploi d’origine
DE
Vor Inbetriebnahme Gebrauchsanweisung lesen!
Gebrauchsanweisung - Originalbetriebsanleitung
Uputstvo za uporabu - Prijevod originalne upute za uporabu
Prije stavljanja u pogon proèitajte uputstvo za uporabu!
HR
Navodila za uporabo
- Prevod originalnega navodila za uporabo
Pred uporabo preberite navodilo za uporabo!
SI

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Ikra IBF 25-1 and is the answer not in the manual?

Ikra IBF 25-1 Specifications

General IconGeneral
BrandIkra
ModelIBF 25-1
CategoryBrush Cutter
LanguageEnglish

Summary

INTENDED USE

EXPLANATION OF THE INFORMATION PLACARD ON THE DEVICE

RATINGS

SAFETY REQUIREMENTS

TRAINING

Learn controls, operation, and engine stop procedures.

PREPARATION

Wear proper clothing, check machine condition, fuel safety, and parts.

OPERATION

Start in ventilated space, use daylight, maintain stable position.

MAINTENANCE AND STORAGE

TRANSPORTATION AND HANDLING

Turn off engine, use guards, secure for transport, handle by grips.

SCOPE OF DELIVERABLES

BEFORE COMMISSIONING

ASSEMBLY

Attach handle holder, handlebar, and clamp using screws.

FUEL AND OIL

FUEL

Use 2-stroke petrol mixed with 40:1 oil; follow specific mixing instructions.

STARTING THE ENGINE

COLD START

Follow steps: ignition, choke, fuel pump, throttle, starter rope.

STARTING WARM ENGINE

Do not use choke; follow cold start steps 1, 4, 6, 7.

STOPPING THE ENGINE

Release throttle, idle engine, then set ignition switch to STOP.

OPERATING ADVICE

TRIMMING

Cuts grass and brush near fences, walls, and tree trunks.

TRIMMING / MOWING

Use side-to-side swing, keep head parallel to ground for even cutting.

Low trimming

Lead trimmer slightly forward, just over ground, away from the body.

TRIMMING AT FENCES AND FOUNDATIONS

Trim slowly, avoid contact with obstacles to prevent kickback.

TRIMMING AROUND TREE TRUNKS

Approach trunks slowly, avoid striking trees to prevent damage.

CUTTING WITH THE CUTTING BLADE

SCYTHING

IF THE CUTTING DEVICE GOT STUCK

AVOIDING KICKBACKS

Extending the cutting cord

Replacing the cutting cord

MAINTENANCE AND REPAIR

AIR FILTER

Remove, clean with soap/water, let dry, and reinstall filter.

TANK CAP / FUEL FILTER

CARBURETTOR SETTINGS

SPARK PLUG

SHARPENING THE CORD CUTTER

TRANSPORT

STORAGE

REOPERATION

CORRECTING FAILURES OF THE ENGINE

Waste disposal and environmental protection

Warranty

Spare parts

SERVICE

Related product manuals