To Next PageTo Next Page
Need help?Do you have a question about the iLight SCI1205 and is the answer not in the manual?
Discusses optimal placement, ventilation, and spacing for Source Controllers.
Details the steps for mounting and connecting the Source Controller unit.
Explains how to connect power and load cables to the controller terminals.
Defines the format, start/end characters, and parameters for ASCII control commands.
Lists commands for system-wide control like scene selection, level setting, and fading.
Outlines steps for initial setup, configuration, and energization of Source Controllers.
Explains the functions of the service switches for diagnostic and override modes.
Describes the meaning of LED indicators for operation, messages, and faults.
Lists the main capabilities and design attributes of iLight Source Controllers.
Details terminal sizes, memory, fade times, and mains stabilization ratio.
Highlights specific features of inductive load controllers, including operation.
Highlights specific features of HF ballast controllers, including load type suitability.
Highlights features of switched relay controllers for resistive, inductive, and capacitive loads.
Highlights features of adaptive controllers, including auto-sensing and protection.
Highlights features of trailing edge controllers, including compatibility with electronic transformers.
General| Brand | iLight |
|---|---|
| Model | SCI1205 |
| Category | Controller |
| Language | English |
