To Next PageTo Next Page
Need help?Do you have a question about the iLight SCI0405 and is the answer not in the manual?
General| Manufacturer | iLight |
|---|---|
| Product Type | Controller |
| Channels | 4 |
| Dimming Range | 0-100% |
| Protection | Over temperature |
| Humidity | 10-90% non-condensing |
Warning regarding high voltages and disconnection before servicing.
Guidance on suitable locations, ventilation, and spacing for Source Controllers.
Steps for physically installing the Source Controller unit and fixing it.
Details on calculating supply size and connecting loads to the controller.
Instructions for connecting the main power supply cables to the controller.
Details on connecting individual load circuits to the controller's terminals.
Specific guidance for connecting low voltage cables for HF Ballast controllers.
Information on configuring HF ballasts for analogue or DSI control.
How to wire emergency luminaires requiring a permanent live feed.
Guidelines for routing CAT5 data cables for network connectivity.
Rules for separating control data cabling from power wiring for safety and noise immunity.
Recommended cable types and wiring pairs for the iCANnet network.
Details on the RS485 terminals for external system communication.
Information on the RJ12 socket for local programming or PC interface.
How to connect a fire alarm system to the alarm input terminals.
Defines the general format, start/end characters, and parameters for ASCII commands.
Explains messages for system-wide control, not individual devices.
Details on commands like SS, SA, RS, RE, SC, RC, RL, CR, CL, SF, TC.
Illustrates how control panels and source controllers connect in an iCANnet network.
Steps and considerations for setting up and configuring the system after installation.
Outlines the default controller settings and pre-programmed scenes.
Explains the uses of the two service switches for diagnostic and override modes.
Describes the meaning of different LED states for operation and faults.
Details on entering, operating within, and exiting diagnostic and override modes.
Lists the primary capabilities and characteristics of iLight Source Controllers.
Covers physical dimensions, weight, climate range, and humidity limits.
Details control interfaces, terminal sizes, fade times, and mains stabilisation.
Lists models with standard mains isolators and special order variants.
Lists specific Inductive Source Controller models and their configurations.
Covers key features, electrical data, load types, and minimum load for inductive models.
Lists specific HF Ballast Controller models and their configurations.
Covers key features, electrical data, and load types for HF Ballast Controllers.
Lists specific Switched Relay Controller models and their configurations.
Covers key features, electrical data, and load types for Switched Relay Controllers.
Lists specific Adaptive Source Controller models and their configurations.
Covers key features, electrical data, load types, and minimum load for adaptive models.
Lists specific Trailing Edge Source Controller models and their configurations.
Covers key features, electrical data, load types, and minimum load for trailing edge models.
