iLive IKBC384SMP3U - CD Player Functionality; Loading and Playing CDs; CD Programming and Repeat

CD Player
Loading and Playing a CD
Note:This unit is compatible with MP3 CDs.
1. Press the Power button to power on the under cabinet music system.
2. Press the Source button to select CD.
3. Press the OpenlClose button to open the DiscTray and place a disc into the tray, label side facing up.
4.
Press the OpenIClose button to close the disc tray.The display will show the total number of tracks on the CD
after a few seconds.
5. Press the PlayIPause button to start playing.
6. Use the controls on the remote or the under cabinet music system to pause, adjust volume, etc.
Programming a CD
Note: Please makes sure the unit is stopped and in CD mode when trying to program.
1. While in CD mode, press the
Prog button.The display will show "POI"
2. Use the SkipITune buttons to select the desired audio track. Press the Prog button to confirm selection.
3. The display will advance to "P02" repeat step
2 to program up to 20 tracks (99, if using a MP3 CD).
4. When the maximum number of tracks are programmed the display will read "FUL" to indicate the program list is
full.
5. When you have completed programming, press the PlayIPause button to begin the program. Audio tracks will
now play in the designated order.
6. To cancel a program, press the Stop button twice.
CD Repeat Mode
With the repeat feature you can choose to repeat one song, a folder or repeat all tracks.
1. To repeat a track press the Repeat button once. The display will show " 0 1" indicating the unit will begin
replaying the current track.
2. Press the Repeat button again to repeat a folder, the display will show " 0 FOLDER. " Note: If there is no
folder this function cannot be selected.
3. Press the Repeat button again to repeat all, the display will show " 0 ALL. "
4. To cancel the repeat function, press the Repeat button until the repeat indicator on the display turns off.