EN
41
H
ICH
L
MI
N
O
P
QN
Leave the descaling solution inside the machine (switched off) for approx. 10-15 minutes
Repeat steps ( ) to ( ) until the descaling solution in the tank is completely used
When the descaling solution is finished, remove the water tank, rinse it carefully and fill it again with fresh
drinking water
Turn the machine on by moving the main on/off switch to the " " position
Without waiting for the machine to warm up, run water through the machine by turning the knob counter
clockwise
When the tank is empty, move the knob back to the central position
Empty rinsing water from the container
Fill the water tank again and repeat the steps described from point ( )
After performing a second rinsing cycle, fill the tank again. Now the appliance is ready for use. After descaling has
been completed, replace the pannarello wand on the steam tube
9
10
11
12
WARNING:
If descaling is not performed as needed, calcium may cause malfunctioning not covered by the warranty
It is advisable to use our descaling agent
Do not use vinegar, lye, salt, formic acid because they may damage the machine
The descaling solution must be totally disposed of according to the specific laws and regulations of your area
H
2
O
9
10
8
7
11
12
30
To Next Page
Loading...
