Need help?Do you have a question about the iLO DTV2794 and is the answer not in the manual?
Accesses the service mode to release the V-CHIP PASSWORD.
Initializes factory TV data, including channel settings and power-on hours.
Allows checking the initial data stored in the MEMORY IC.
Verifies SUM DATA, MICON VERSION, POWER ON hours, and Digital TV MICON Firmware.
Activates the display of the adjustment menu for various settings.
Confirms check sums, power-on hours, and version information before EEPROM replacement.
Guides the process of confirming and inputting initial data for a new MEMORY IC.
JIG used for connecting the TV set to a personal computer for communication.
Software disc for updating the TV's firmware.
Disc containing ROM data for updating Digital TV firmware.
Steps for rewriting the digital soft firmware using specified tools and discs.
Overview of the procedure for electrical adjustments, including cautions and required tools.
Instructions for adjusting the On-Screen Display settings.
Procedure for adjusting the constant voltage to 130 ± 0.5V.
Procedure for adjusting the screen volume to obtain a dim raster.
Steps to adjust white balance by setting R.BIAS, R.DRIVE, B.DRIVE, G.BIAS, B.BIAS.
Procedure for adjusting the focus volume to achieve a distinct picture.
Procedure for adjusting brightness center for different input modes.
Procedure for adjusting the maximum contrast level.
Procedure for adjusting the tint setting until section A becomes a straight line.
Procedure for adjusting color center to achieve specific red color level.
Procedure for adjusting horizontal position to minimize over scan shift.
Procedure for adjusting horizontal size to achieve specific over scan.
Procedure for adjusting vertical linearity to minimize over scan.
Procedure for adjusting vertical position to fit horizontal line to shadow mask notch.
Procedure for adjusting vertical size to achieve specific over scan.
Procedure for adjusting trapezium to make vertical lines parallel.
Procedure for adjusting parabola correction to straighten lines.
Procedure for adjusting corner top and bottom to make vertical lines straight.
Procedure for adjusting OSD horizontal position to minimize difference.
Confirms if the fixed values of each adjustment item are set correctly.
Procedure for rough adjustment of static convergence using magnets.
Procedure for adjusting purity magnets to center color and ensure equal width.
Procedure for aligning red and blue, then magenta and green convergence.
Procedure for adjusting convergence differences using deflection yoke and wedges.
Guide showing parts location and wiring connections for CRT and TV main PCBs.
To Next Page
General
