ILUMINAGE PRECISE TOUCH - Treatment Tips for Optimal Results

16
EN
17
EN
STEP 3:
TREATING YOUR BODY
Gently place the device on your skin, so that both RF contact
bars are in complete contact with the skin (image D). The
device will not work unless both RF contact bars are touching
your skin.
• The PRECISE TOUCH will emit flashes of bright light - this is
the elōs energy at work.
• Slowly glide the device over the treatment area, without
lifting the device move to the next spot only after the
treatment flash has been emitted.
• Continue gliding the device over the area so that you pass
over the same area 2-3 times.
STEP 2:
ACTIVATE
Press the power button to turn on your PRECISE TOUCH
device and select your energy level (LOW, MEDIUM or HIGH):
• LOW: Press the elōs button once to select the lowest energy
level. The left energy level indicator light will turn blue
(image A) and you will hear the fan inside the device.
• MEDIUM or HIGH: Use the elōs button to select higher
energy levels for greater ecacy (image B, C). Always start
treating on LOW and if you are comfortable, move to ME-
DIUM or HIGH energy level for greater ecacy.
TREATMENT TIPS
When using the PRECISE TOUCH on dicult to treat areas (e.g.
underarms) apply the device in two directions: left/right and
up/down for full coverage (image A).
• If you find the light from the elōs flash too bright, you can
wear sunglasses or goggles for your comfort.
• DO NOT hold the treatment window still over one spot and
flash multiple light flash on the skin. Doing so may generate
too much heat, which can damage the skin.
• The PRECISE TOUCH will automatically shut o if it is not in
use for more than 3 minutes. Press the power button to turn
the device back on.
STEP 4:
TREATING YOUR FACE
Prepare your treatment area (women's faces below the cheek
line):
• You can shave (dark hair), wax or tweeze (light hair) before
using the PRECISE TOUCH.
• Make sure to clean your skin of any wax or hair residue before
starting treatment.
• Do not treat if you feel your skin is irritated from waxing or
tweezing.
• Gently place the device on your skin, so that both RF bars are in
complete contact with the skin. The device will not work unless
both RF contact bars are touching your skin.
• Allow one flash of elōs energy on your first target area.
• Lift the device and place it on the the next adjacent area and
wait for each flash of elōs light to be emitted before moving to
the next spot.
• Repeat until you have completed 2-3 passes of the entire area.
USING YOUR PRECISE TOUCH FOR THE FIRST TIME USING YOUR PRECISE TOUCH FOR THE FIRST TIME
low/ faible medium/ moyen
high/ élevé
skin surface/ surface de la peau
A
B
C
D
A